Wuhan Guide IR136 Bedienungsanleitung PDF herunterladen (Seite 17)

User Manual

! Press the softkey labeled “Yes”.

Adding Voice Annotation to Saved Data

Voice annotation can only be added to an image prior to storing it. After capturing an image, the Image Capture menu

appears. To add a voice annotation to the image:

! Press the softkey labeled “Voice”.

! Press the softkey labeled “Record” to start the recording.

! Speak into the Imager’s microphone opening. When done recording, press the softkey labeled “Stop”. Up to 60

seconds of voice annotation can be recorded for each image. Once it reaches 60 seconds, recording will stop

automatically.

! Press the softkey labeled “Play” to replay the voice annotation before saving.

! Press the softkey labeled “Save” to save the video annotation.

Listening to Voice Annotation

To play the voice annotation already stored with an image on the UFlash or SD card:

! Perform the steps in the “Reviewing and Deleting Stored Images” section to bring the desired image to the SPI®

RAZ-IR MAX ’s display.

! Press the softkey labeled “Voice”.

! Press the softkey labeled “Play”

The saved voice annotation will be replayed through the imager’s speaker.

Changing the Temperature Units

The SPI® RAZ-IR MAX will display temperature in Fahrenheit or Celsius. To change the temperature units:

! Press to display main menu

! Press the softkey labeled Setup

! Press the softkey labeled Tunit

! Press for Celsius or for Fahrenheit.

Doing spot analysis

SPI® RAZ-IR MAX supports single spot measurement. The location of center spot can be adjusted in live image:

! Press button and then button to bring location adjustment mode of center spot.

! The default adjustment mode is “L/R” mode, press and “M” button can move the center spot to left and

right under this mode; press “P” button to switch into “U/D” mode, then press and button can

move the center spot to up and down under this mode. Press “P” button can switch between the above two modes

freely.

! Press “trigger” button can save and exit the location adjustment mode of center spot.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22

Keine Kommentare

Wuhan Guide IR136 Bedienungsanleitung Seite 17